Point Grinding Machine:
For one end pointing of straight wire, blanks, which are fed from the coil. The blanks are guided by two transport spindles along two grinding units in the band area rubbers are pressing the blanks, so that they will rotate during transportation. The grinding bands are adjustable in all levels corresponding to required point form. Drive of the spindles by chain and of grinding unit by V - belt.
Size of Product |
Wire Size |
Production Per Minute |
| 50mm to 85mm |
0.7mm - 0.9mm |
85pcs. |
| Area required |
Motor H.P. & R.P.M.
|
Machine weight |
| 5' x 7' (Working area) |
1/2 H.P. & 1 H.P. x 1440
|
600 Kg. Approx. |
Cap Manufacturing Machine:
For making caps from strip. Strip coil is feeded on the machine which is guided by guide, the blank is cut and then forced drawn through die to make required size and shape. The remaining strip is collected after the stamping automatically. Drive in all sections is by V-belts.
Gauge of Strip |
Strip Size |
Production Per Minute |
| 50mm to 85mm |
0.7mm - 0.9mm |
85pcs. |
| 0.25mm |
16mm - 20mm |
85 pcs. |
| Area required |
Motor H.P. & R.P.M. |
Machine weight |
| 4' x 7' (Working area) |
1 H.P. x 1440 |
400 Kg. Approx. |
Assembly Machine:
The cut-off and pointed shanks are fed from the magazine to the winding section on spindles drive. Simultaneously cap from strip is put into boul and feeded into magazine automatically with the help of feeding rods. The assembly and pressing of cap onto the shank is done by an integrated assembly section in the machine. The shank than is winded in winding section of the machine. The drive in all sections of the machine is by V - belts.
Size of Product |
Wire Size |
Production Per Minute |
| As per feeding |
As per feeding |
85 pcs.. |
| Area required |
Motor H.P. & R.P.M. |
Machine weight |
| 4' x 4' (Working area) |
1 H.P. x 1440 |
600 Kg. Approx. |
Beside that nickle plating plant is also essential for the above machines
Note: Measurements, Design, Output & Weight etc. are subjected to change without notice.
|
